- Products
- High performance concrete KALCRET
- Fused cast basalt ABRESIST
- Zirconium corundum ceramics KALCOR
- High alumina ceramics KALOCER
- Silicon carbide ceramics KALSICA
- Hard ceramics KALCERAM
- Epoxy-bonded hardcompound KALPOXY
- Composite construction of hard material and rubber KALIMPACT
- Hard casting KALCAST
- Hard overlay welding KALMETALL
- Slide promotion plastics KALEN
- Sprayable Polyurea KALEA
- Applications
- Service
- Company
- Career
- Contact
Filtering and separating
Cyclone
Filtering and separating
Wherever bulk materials are separated, sorted or graded, plant components are subjected to wear. Kalenborn offers a broad range of wear protection solutions. Our solutions protect your cyclones, separators, screens and other equipment components against wear.
Wear protection for cyclones
Along with the hardness of the materials being sorted, flow rate is a major factor that affects wear. In cyclones, particles sometimes reach significant speeds, which cause tremendous wear. Wear protection linings must be not only strong but also extremely lightweight, to add as little as possible to the overall weight of the equipment component.
Cyclone with KALOCER mats and fittings
Classifier system with KALOCER
Wear protection for sifters
Different sifters are used depending on the characteristics of the mixture. The material is separated according to particle size or material properties in an air stream, by gravity or centrifugal force. Elevated temperatures or rapid temperature changes can also occur, which have an impact on both the correct choice of wear protection materials and the means of installing that protection (adhesive, mechanical, etc.) in separators.
Wear protection for sieves
Sieves are used to sort material according to different grain sizes. Depending on the hardness and grain size of the material, the frictional motion generated in the process causes considerable wear. It is important that the sieves used for this purpose continue to separate the desired grain sizes within the specified tolerances for as long as possible. Selection of the correct wear protection material is optimized according to the specific process parameters.
Dust separator with KALCRET
DRI reactor with KALCOR
Wear protection for reactor cones
In the DRI direct reduction process, oxygen is removed from the iron ore by means of reducing gases to obtain sponge iron. This requires a temperature optimized lining system for the reactor cone. In cooperation with Danieli, Kalenborn has special experience in this field to meet the requirements for CO2-minimised steel production.
Our plant parts for wear protection
- Cyclones
- Reactor cones
- Venturi
- Sifters
- Sieves
- Filter presses
- Dryers
- Separators
User reports wear protection
Processes
Plant components
Industries
